This can be a useful way to monitor the input signal. Graphic meter - This displays the level of the signal in dBFS before the fader. Double-clicking on this control will centre the control and send an equal amount of the signal to the left and right channels.įader - The controls the level of the signal in that particular mix. Pan control - This controls the amount of the signal sent to the left and right channels of the mix. This can be a physical input or a DAW output and can be changed by clicking on the current input name. Mixer channel input - This controls the input for the respective input channel. Each mixer channel consists of the following. This tutorial will explain the features and settings of MixControl to allow the greatest amount of control over your interface.Įach mix allows analogue and digital inputs to be blended together with software outputs before being routed to a physical output. Scarlett Mix Control is the control software that is used to control the output routing and settings for the Scarlett interface range. Saffire MixControl is the control software that is used to control the output routing and settings for the Saffire interface range. Realizing this got 3 more cables off my desk (yay).Applies to: Saffire Pro 40, 26, 24, 24DSP, 14, Scarlett 18i20 (1st gen), 18i8 (1st gen), 6i6 (1st gen) and LS56 When recording, I muted the recording track to prevent feedback from it.I really wish I had realized it was this simple a year ago. Create an audio track with Saffire Loop1 as the input.Modify DAW 1/2 to a mix if preferred for more versatility. Loopback DAW 1/2 in the router settings (to record "What you Hear").Have Windows sounds run through the Saffire.For those interested, the "quick and dirty" way to use this is to: What didn't make sense until I actually did this is "DAW 1/2" is actually the Saffire "main outs" as far as that "Loop 1" input is concerned. Since I run Windows sounds on my RealTek, I rarely shift the computer "as a whole" to the Saffire. I am glad this happened to me, since I read the manual a couple times which doesn't give focus to this important detail (although it mentioned the loopback routing, I didn't catch the "Loop 1" input). It is quite possible I disabled this, but I thought I had only disabled SPDIF/ADAT channels. apparently this input driver is to streamline routing, and a quick test of this works like a charm. I am sure other interfaces have similar features and know that it could be done previously with the Saffire 24, but a feedback loop was a serious issue (many warnings in the Saffire manual on this too). This came to mind from this thread, but I wanted to throw this out for folks. No physical loopback cabling required (yay Focusrite. with MixControl 3.4, whatever signal is assigned to LoopBack (mix of your choice) is sent to this input driver, so is very simple to create an audio track, select "Loop 1" as the input and record "what you hear" like in the days of old. As I was setting up things again, there is now an "ASIO Saffire Pro 24 Loop 1" input driver which I swear did not exist before (anyone know if this is new to MixControl 3.4, or did I just miss it before?). I was just playing with Re-Wire and accidentally installed another set of ASIO drivers which caused me to delete that software. Track Loopback - Focusrite Saffire MixControl
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |